LG top-load washer error codes

If the lid is closed and this message appears when you start the cycle, unplug the washer and check the wire harness connection on the lid lock/switch assembly. If the wiring connections are sound, the lid lock/switch usually needs to be replaced.

Check for debris in the lid lock assembly that could prevent the lock mechanism from engaging. Unplug the washer and check the wiring connections on the lid lock/switch assembly. If you find no wiring problems, you usually need to replace the lid lock/switch assembly.

The washer usually is filling continuously because a water valve failed. Unplug the washer and shut off the water supply. The water inlet valve assembly usually needs to be replaced.

The control detects a problem with the clutch motor. Unplug the washer. Check the wiring harness connections between the main electronic control board and the clutch motor. If the wiring connections are sound, the clutch motor or the main electronic control board usually needs to be replaced.

If a small load is in the washer, add a few towels or garments to the load. If the load is a normal size, then redistribute the load and see if the washer spins. If the washer tub moves and bangs violently during the spin cycle, one or more of the suspension rod/spring assemblies may need to be replaced. Unplug the washer and examine those components.

If a small load is in the washer, add a few towels or garments to the load. If the load is a normal size, redistribute the load and see if the washer spins. If the washer tub moves and bangs violently during the spin cycle, one or more of the suspension rod/spring assemblies may need to be replaced. Unplug the washer and examine those components.

Unplug the washer and check the wiring between the control board and the thermistor (temperature sensor). If the wiring is sound, measure the resistance of the thermistor. It should read between 80,000 and 90,000 ohms) at room temperature. If the thermistor is defective, replace it. If resistance of the thermistor is normal through the circuit, replace the main electronic control board.

Unplug the washer and check the wire harness connections between the water level sensor and the electronic control board. Reconnect any loose wires or replace the wire harness if damaged. If the wire connections are okay, replace the water level sensor.

A failed drive motor or a restriction in the drive system of the washer causes this code to be displayed. Unplug the washer. See if the basket spins freely. If not, examine and repair the cause of the restriction in the drive system. If the basket spins freely, check the wiring connections between the drive motor and the control board. Check the resistance through the drive motor windings. The winding should measure between 5 and 15 ohms. If the motor is defective, replace it.