Official Caloric electric range parts

Frequently-replaced parts in Caloric electric ranges

• Electronic oven control board. The electronic oven control (EOC) board governs the timing and execution of oven functions in the range. It's usually attached to the control panel and often has a digital display clock mounted on the front of its housing.
• Outer oven door glass panel. The outer oven door glass panel is the heat-resistant piece of glass that forms the outer part of the oven door.
• Oven door hinges. The hinges on an oven door control the rate at which the door opens and also allow the door to stay open at an angle. Hinges are usually installed in pairs so the hinges and tension springs match, ensuring the smooth operation of the door.
• Oven door lock assembly. The oven door lock assembly is a safety mechanism that prevents accidental burns and oven fires by latching the door shut during self-cleaning. The door unlocks when the oven cools to a safe temperature (usually less than 200 degrees F). It's also used on ovens with the child lock-out feature. The assembly includes the lock and switches that detect whether the door is locked.
• Bake element. The bake element is at the bottom of an electric oven and provides heat for baking.

How to replace the oven temperature sensor in your Caloric electric range

• Shut off electrical power to the range.
• Remove the oven racks.
• Remove the screws from the base of the temperature sensor probe.
• Carefully pull the oven temperature sensor probe forward into the oven interior. The wires connected to the probe have enough slack that you can pull it a just few inches. Holding the connector with needle-nose pliers, depress the locking tab on the plug and disconnect the plug from the sensor probe. Don't let the connector slip back through the hole, or you must remove the back panel of the oven to retrieve it.
• While holding the connector with a pair of needle-nose pliers, snap it into the plug of the new probe. Push the wire into back wall of the oven. Position the new sensor probe and line up the holes for the mounting screws. Insert the mounting screws and tighten firmly using a nut driver.
• Reinstall the oven racks and restore electrical power to the range.