Official Thermador wall oven/microwave combo parts

Top replacement parts for Thermador wall oven microwave combos

• Oven door handle. The oven door handle allows you to open and close the oven door.
• High-limit thermostat. The high-limit thermostat trips when it detects that the oven is overheating.
• Relay control board. The relay control board gets signals from the main electronic control board and the relay control board opens and shuts relays that send electrical current to the bake and broil thermostats to help control oven heating.
• Convection fan. The convection fan circulates air through the oven cavity to evenly heat foods in the oven.

Replacing oven door hinges in your Thermador wall oven microwave combo

• Fully open the oven door. Use a slot screwdriver to pry down the locking tabs to the unlocked position on both sides of the door. Raise the door to the broil stop position, which is about 1/4 open. Grip both sides of the oven door and then lift up and out to remove the door.
• Carefully place the oven door face down on a padded surface, such as a towel-covered table. Using the type of screwdriver that fits the screws, remove the screws that secure the door handle to the top of the oven door. Remove the handle.
• Remove the screws at the bottom of the oven door. Lift the inner door panel assembly off the outer door panel and set it on the padded surface.
• Remove the 2 screws on the inner oven door panel that secure each door hinge in place. Pull the hinges up and out of the inner door panel.
• Position the new door hinges in place in the inner door panel assembly. Insert the screws in the new door hinges and tighten the screws firmly.
• Reassemble the door and reinstall the door on the oven.