Official Formula Ventures stepper parts

Replacing the control console on your Formula Ventures stepper

• Remove the mounting screws from the console bottom.
• Pull the control console up to access the wire harness plug on the bottom of the console. Release the wire harness plug locking tab and disconnect the console wire harness.
• Position the new control console near the top of the console mounting frame and connect the console wire harness to the new control console.
• Reinstall the console mounting screws to secure the new control console to its frame.
• Install batteries in the new control console.

What to do when the control console display is dim on your Formula Ventures stepper

Weak batteries, loose wires or a faulty console can cause a dim control console display on your stepper.

In a stepper that uses batteries to power the console, replace the batteries to restore brightness to the console display. Replace the batteries during routine stepper maintenance to keep the control console display from going dim in the future.

If the display doesn't get brighter after replacing the batteries, you'll likely need to replace the console.

If your stepper has a power cord, unplug the stepper and check the power cord wiring connections to the control console. Reconnect any loose wires. If the power cord is damaged, replace it.

If the power cord and its wiring connections to the control console are okay, then you may need to replace the console because the display is faulty or the console isn't sending enough power to the display.