How to replace a riding lawn mower fuel filter
This step-by-step riding mower repair guide shows how to replace the fuel filter in a riding lawn mower. The fuel filter keeps dirt from getting into the carburetor. A clogged or dirty fuel filter doesn’t let enough fuel reach the carburetor, so the engine run roughs or stops running completely. Remove the old fuel filter and install a new one when you tune up your lawn tractor each year, using a manufacturer-approved lawn mower part.
This procedure works for common Briggs & Stratton engines that power Craftsman, MTD, Husqvarna, Murray, Toro, Troybilt, Snapper, Yard-Man, Ariens, Poulan and John Deere riding mowers and lawn tractors.
This video explains how to replace the fuel filter on a riding lawn mower.
Instructions
- 01.
Disconnect the spark plug
Park the tractor on a level surface in a well-ventilated area.
Set the parking brake.
Turn the ignition switch off and remove the key.
Let the engine cool.
Wear work gloves to protect your hands.
Lift the tractor hood and disconnect the spark plug wire.
Tip: Disconnect both spark plug wires if your tractor has 2 cylinders.PHOTO: Disconnect the spark plug.
- 02.
Remove the old fuel filter
Remove the lower dash fastener and pull off the lower dash.
Clamp hose pinch-off pliers onto the fuel line on each side of the fuel filter to block the flow of fuel.
Position the shop rag under the fuel filter to catch drips.
Release the hose clamps and remove the hose from each side of the fuel filter.
Wipe up any spilled fuel.
PHOTO: Clamp off the fuel line.
- 03.
Install the new fuel filter
Connect the hose on each side of the new fuel filter using the hose clamps.
Release the hose pinch-off pliers from each side of the fuel filter.
Reinstall the lower dash and secure it with the fastener.
PHOTO: Install the new fuel filter.
- 04.
Reconnect the spark plug
Reconnect the spark plug wire and lower the tractor hood.
Tip: Reconnect both spark plug wires if your engine has 2 cylinders.
Most common symptoms to help you fix your riding mowers & tractors
Choose a symptom to see related riding mower and lawn tractor repairs.
Main causes: faulty battery, bad alternator…
Main causes: damaged cutting blade, worn deck pulley, damaged mandrel pulley, loose fasteners on mower deck components…
Main causes: damaged tie rods, bent or worn wheel spindle, worn front axle, damaged sector gear assembly…
Main causes: worn or broken blade belt, broken belt idler pulley, blade clutch cable failure, bad PTO switch, damaged ma…
Main causes: punctured tire or inner tube, leaky valve stem, damaged wheel rim…
Main causes: engine overfilled with oil, leaky head gasket or sump gasket, damaged carburetor seals, cracked fuel pump, …
Main causes: clogged carburetor, damaged flywheel key, dirty spark plug, stale fuel, improper valve lash, engine needs a…
Main causes: shift lever needs adjustment, neutral control needs adjustment…
Main causes: worn or broken ground drive belt, bad seat switch, transaxle freewheel control engaged, transaxle failure, …
Most common repair guides to help fix your riding mowers & tractors
These step-by-step repair guides will help you safely fix what’s broken on your riding mower or lawn tractor.
How to replace the starter motor on a riding lawn mower
If you hear the solenoid click but don’t hear the starter motor spin when you turn the key, follow these steps to replac…
How to rebuild a riding lawn mower carburetor
Get your sputtering carburetor running smoothly in 60 minutes.…
How to replace a riding lawn mower rear tire
Your mower can’t run on a damaged rear tire. Here’s how to install a new one.…
Effective articles & videos to help repair your riding mowers & tractors
Use the advice and tips in these articles and videos to get the most out of your riding mower or lawn tractor.
Learn about all the convenient features on our Sears PartsDirect website that make your parts purchases easier.…
Get answers to frequently asked questions about Sears and Sears PartsDirect.…
Check the starter solenoid, starter motor, wiring, battery and engine.…