How to replace an in-door ice maker on a French door refrigerator
This refrigerator repair guide shows how to replace the ice maker assembly in a Kenmore Trio refrigerator and a LG French door refrigerator with an in-door ice maker. If the ice maker isn't making ice, replace it with the manufacturer-approved fridge part that fits your model. Follow the step-by-step instructions below to learn how to replace the ice machine and visit our refrigerator repair help page for more repair help and troubleshooting tips.
This repair procedure works for Kenmore Trio and other Kenmore French door refrigerators, as well as LG French door refrigerators. The same basic procedure can also be used to replace in-door ice makers on some Whirlpool, KitchenAid and Maytag French door refrigerators.
Instructions
- 01.
Disconnect electrical power
Unplug the refrigerator or shut off the circuit breaker for the refrigerator. Move highly perishable food to a cooler or other cooled space. The refrigerator will be without power for about 30 minutes, which shouldn't affect most refrigerated or frozen foods.
- 02.
Remove the ice bucket
Open the ice maker compartment door to access the ice maker assembly. Grip the handle at the bottom of the ice bin and pull it up and out of the ice compartment housing.
Tip: Refer to the installation manual for additional help with this step, if needed.
PHOTO: Open the door to the ice maker.
PHOTO: Remove the ice bin.
- 03.
Detach the ice maker assembly
While supporting the ice maker so it doesn't drop, use a Phillips screwdriver to remove the 2 mounting screws that secure the refrigerator ice maker assembly to the ice compartment. Set the screws aside.
Remove the 2 mounting screws that secure the ice maker module to the door.
- 04.
Remove the ice maker assembly
Carefully pull the refrigerator's ice maker down slightly and flip it upside down to access the wire harness and ground wire connections. Push in the locking tab on the wire harness and pull the wire harness out of the connection plug.
Remove the screw that secures the green ground wire to the bottom of the ice maker assembly and set the screw aside. Remove the ice maker and set it aside for disposal.
PHOTO: Lower and flip the ice maker to access its wiring harness.
PHOTO: Locate the ice maker wire harness plug.
PHOTO: Unplug the ice maker wire harness.
PHOTO: Loosen the ground wire mounting screw.
PHOTO: Release the ground wire.
PHOTO: Remove the ice maker.
- 05.
Attach the ground wire
Position the new ice maker assembly in the ice maker compartment and attach the green ground wire to the new ice maker assembly. Tighten the screw firmly.
- 06.
Plug in the wire harness
Insert the wire harness into the new ice maker assembly connection plug and push it in until the locking tab snaps into the locked position.
- 07.
Attach the new ice maker
Flip the ice maker assembly right side up and position it in the ice maker compartment so that the mounting holes are lined up. Insert the mounting screws and tighten them firmly.
Tip: Don't overtighten the mounting screws. Turn the screws until they stop and then give them a reasonably firm twist to secure them. - 08.
Reinstall the ice bucket
Slant the top of the ice bin forward slightly and push the ice bin into the ice compartment. Close the compartment door and the freezer door.
Tip: Refer to the owner's manual for additional help with this step, if needed. - 09.
Restore electrical power
Plug in the refrigerator or turn on the house circuit breaker to restore power.
Most common symptoms to help you fix your refrigerators
Choose a symptom to see related refrigerator repairs.
Main causes: damaged door seal, faulty defrost sensor or bi-metal thermostat, broken defrost heater, bad defrost timer o...
Main causes: control board or cold control failure, broken compressor start relay, compressor motor failure, defrost tim...
Main causes: blocked vents, defrost system problems, evaporator fan failure, dirty condenser coils, bad sensors, condens...
Main causes: leaky door gasket, defrost system failure, evaporator fan not running, dirty condenser coils, condenser fan...
Main causes: jammed ice cubes, broken ice maker assembly, dirty water filter, kinked water line, bad water valve, freeze...
Main causes: blocked air vents, compressor problems, condenser or evaporator fan not working, control system failure, se...
Main causes: water valve leaking, frozen or broken defrost drain tube, overflowing drain pan, cracked water system tubin...
Things to do: clean condenser coils, replace the water filter, clean the interior, adjust doors to prevent air leaks, cl...
Most common repair guides to help fix your refrigerators
These step-by-step repair guides will help you safely fix what’s broken on your refrigerator.
How to replace a refrigerator water valve
Replace the water valve that feeds water to the ice maker and water dispenser if it no longer controls the flow of water...
How to replace a refrigerator temperature control board
If the temperature in your refrigerator doesn't match the temperature you set, the problem could be the temperature cont...
How to clean refrigerator condenser coils
Help your refrigerator run more efficiently by cleaning the condenser coils. It's easy and takes just a few minutes....
Effective articles & videos to help repair your refrigerators
Use the advice and tips in these articles and videos to get the most out of your refrigerator.
No matter what style Maytag refrigerator you have, we can walk you through replacing the water filter....
Learn about all the convenient features on our Sears PartsDirect website that make your parts purchases easier....
If your refrigerator's ice maker isn't producing as much ice as it should, or water is flowing poorly from the dispenser...