Official Kenmore floor scrubber parts

How to clean the brushes on your Kenmore floor scrubber

• Unplug the power cord from the electrical outlet to disconnect electrical power.
• Pull the nozzle release buttons out and remove the nozzle.
• Tilt the floor scrubber back so its handle rests on the floor.
• Push the brush release buttons and remove the brush assembly.
• Wash the brush assembly using mild detergent and rinse the brush assembly thoroughly with plain water. Allow the brush assembly to dry completely.
• Reinstall the brush assembly and reassemble the floor scrubber.

Common replacement parts for Kenmore floor scrubbers

• Base squeegee. The base squeegee fastens to the base assembly to direct water towards the suction area.
• Mode selector dial. The mode selector dial turns the scrubbing brushes on and off.
• Handle release pedal. The handle release pedal allow you to lower the handle to the operating position.
• On/off switch. The on/off switch turns the vacuum motor on and off.
• Brush assembly. The brush assembly scrubs the floor during cleaning.