Official Kenmore health & wellness parts

Repairing damaged wires in Kenmore health & wellness equipment

• Unplug the power cord from the electrical outlet to completely disconnect electrical power before accessing and repairing wiring.
• The first step in this repair is to strip the insulation from the ends of the wire. Always use a wire stripper to strip off the insulation. Using a knife or wire cutter could be unsafe and could also damage the wire strands inside the insulation. Strip 1/4 inch of insulation off the end of the wire.
• Place the bare end of the wire into the connector, leaving none exposed. Repeat the process for the other wire end. Squeeze the connector firmly with a crimping tool so the crimp securely grips the wire. Give the wire connector a couple of firm 'tugs" to see that it's connected and tight.
• Crimped wire connections that could be exposed to water inside an appliance require a heat shrink tube seal to protect the new connection from moisture. Always remember to put the heat shrink tubes on the wire before you crimp the wire ends together. Cover both ends of the connector with the heat shrink tube to create a good seal. Heat the tube using a heat gun or hair dryer until the tube shrinks up and seals the crimp connector.

Safely using your Kenmore health & wellness products

• Always read and follow all assembly instructions, use & care directions and safety precautions listed in the owner's manual for your health & wellness products.
• Inspect health & wellness products for loose, worn, missing or broken parts before use. Tighten any loose screws or fasteners. Replace any worn, missing or broken parts before using the products.
• Disconnect electrical power from electrical products before accessing and replacing internal parts.