Official Kenmore water pump parts

Troubleshooting tips for your Kenmore water pump when it won't start

• Check for electrical power. Check the house circuit breaker. Reset the house circuit breaker for the pump if the circuit breaker tripped.
• Check the pump control settings. Make sure the pump is turned on and the control is set properly.
• Disconnect electrical power and check wiring. Reconnect any loose wires and repair any broken wires.
• If these troubleshooting tips don't help, then you may need to replace control parts or the pump motor.

Frequently replaced Kenmore water pump parts

• Contactor. The pump contactor applies current to the motor windings to run the motor.
• Check valve seat. The pump check valve seat attaches to the pump housing and holds the check valve in place.
• Foot valve. The pump foot valve attaches on the end of the intake hose and prevents water backflow from the pump.
• Pressure regulator. The pressure regulator maintains the output water pressure.