Official Whirlpool upright vacuum parts

Replacing the brush roll drive belt in your Whirlpool upright vacuum

• Unplug the power cord to disconnect electrical power from the vacuum cleaner.
• Turn the vacuum cleaner over so the bottom of the nozzle assembly is facing up.
• Remove the screws from the bottom of the bottom plate.
• Pull the bottom plate off the nozzle assembly.
• Pull out the brush roll and remove the belt from the motor shaft and brush roll.
• Slide the new belt onto the motor shaft and slip the other end of the belt over the brush roll.
• Reinstall the brush roll into the nozzle assembly.
• Reinstall the bottom plate and secure it with the mounting screws.

Maintenance tips for your Whirlpool upright vacuum cleaner

Empty the dirt container as needed when vacuuming so the container doesn't get overfilled with dirt and lint.

Periodically clean the dirt container thoroughly. Remove the lower portion of the dirt container by pressing down on the front latch on the upper portion of the container. Clean the screen with a cloth or soft brush to remove dust and debris from the screen. Wash the lower dirt container with warm water. Allow the lower dirt container to dry completely before reassembling the vacuum.

To reassemble the dirt container, hold the carry handle and position the upper portion of the dirt container into the lower portion. Line up the front and back latches. Push down on the upper portion of the container until both latches click into place. Reinstall the dirt container on the vacuum cleaner.

Clean the pre-motor filter monthly. Open the filter cover and remove the pre-motor filter. Remove the filter and wash it with water. Allow the filter to dry completely before reinstalling it. Reinstall the filter and close the filter cover.