Official Whirlpool gas water heater parts

Top repair parts for Whirlpool gas water heaters

• Temperature cut-off switch. The temperature cut-off switch shuts off the water heater if water temperature gets too hot. Replace the temperature cut-off switch it it's defective.
• Flammable vapor sensor. The flammable vapor sensor shuts off the gas supply to the water heater if it detects flammable vapors. A service technician needs to investigate the cause of a flammable vapor sensor trip before the water heater can be put back into service. The service technician will replace the flammable vapor sensor if it isn't working properly.
• Gas valve assembly. The gas valve assembly monitors tank water temperature and cycles the burner on and off to maintain set water temperature.
• Temperature-pressure relief valve. The temperature-pressure (T&P) relief valve is a safety device that automatically opens to discharge hot water in the event of excessive temperature and/or pressure inside the tank. Replace the T&P valve if it leaks or malfunctions.

Maintenance tips for your Whirlpool gas water heater

• Flush tank sediment every 6 months. It is recommended that you drain the tank and flush sediment out of the tank every six months. Sediment can build up and interfere with water heating if you don't regularly drain and flush the tank.
• Visually inspect the vent system annually. Look for obstructions or damage to the vent system. Make sure that ventilation air paths aren't obstructed.
• Check piping systems for leaks yearly. Repair or replace any leaking pipes or water fittings.
• Annually inspect gas lines and the burner for damage or corrosion. Have a service technician repair any damaged gas lines or replace the gas burner if it's damaged.