Penfield water heaters are often installed and then forgotten until there's no hot water or the water gets cold halfway through a shower. If your Penfield water heater doesn't heat quickly enough, doesn't heat at all or your hot water smells like rotten eggs, find the replacement parts you need to fix the problem at Sears PartsDirect.
How to replace an electric heating element in your Penfield water heater
Switch the 2 house circuit breakers dedicated for the water heater to OFF. Wear work gloves to protect your hands.
Turn off the cold water supply to the water heater. Attach a garden hose to the drain valve located at the bottom of the unit and run the garden hose outside. Open a hot water faucet in the house or flip the relief valve open on the water heater. Open the drain valve and allow the tank to drain until empty.
Remove the heating element’s access cover mounting screw and pull off the cover. Fold the insulation back to expose the heating element. Lift up the tab located at the top of the plastic shield to release the shield from the thermostat and remove the shield. Loosen the screws securing the wires to the heating element and disconnect the wires. Unscrew the heating element from the tank using a heating element socket. Pull the heating element out of the tank.
Insert the new heating element in the tank and tighten firmly. Reconnect the wires to the new heating element and tighten the screws. Reinstall the plastic shield over the thermostat and heating element. Fold the insulation back over the thermostat and heating element. Reinstall the heating element cover and screw.
Close the drain valve and remove the garden hose. Flip the relief valve to the closed position. Turn the cold water supply on to the water heater and allow the tank to fill with water. Once you see water coming out of the hot water faucet, turn the hot water faucet off.
Flip the house circuit breakers to the on position.
How to replace the anode rod in your Penfield water heater
Shut off the house circuit breaker or circuit breakers for your water heater to completely disconnect electrical power. If you have a gas water heater shut off the gas supply.
Turn off the cold water supply to the water heater. Attach a garden hose to the drain valve located at the bottom of the unit and run the garden hose outside. Open a hot water faucet in the house or flip the relief valve open on the water heater. Open the drain valve and allow the tank to drain about 5 gallons of water and then close the drain valve and remove the garden hose.
Pry the plastic cap off from the top of the water heater covering the anode rod. Remove the foam insulation covering the anode rod. Unthread the anode rod and pull it up and out from the tank.
Wrap pipe thread-sealing tape around the threads of the new anode rod. Thread the new anode rod into the tank and tighten firmly. Reinsert the plastic cap.
Turn the cold water supply on to the water heater and allow the tank to fill with water. When water begins to flow from the open hot water faucet, turn the hot water faucet off.
Restore the electrical power supply (and gas supply for a gas water heater) to the water heater.
When you’re looking for hot water repair near me, trust the pros at Sears Home Services to fix your water heater fast.
Error Codes
