Official Legacy weight system parts

Top-selling Legacy weight system replacement parts

• Cables. Weight system cables connect arms and handles to their weight stacks.
• Pulleys. Pulleys support and guide cables through the weight system frames.
• Weight tubes. Weight tubes support and guide weights up and down on the weight stacks.
• Fasteners. Fasteners such as bolts, nuts and screws can loosen and fall out over time. Replace any missing fasteners on the weight system before use.

Tightening the cables on your Legacy weight system

• Cables stretch over time so inspect the slack in all weight system resistance cables before using the weight system each time.
• Tighten any loose cables to eliminate slack before using the weight system. Don't overtighten the cables.
• To tighten cables that use a bolt and locknut adjustment, slide the cable stop away from the cable clip. Use a pair of pliers or a screwdriver to tighten the locknut on the bolt that goes into the cable clip to shorten the cable and remove slack. Slide the cable stop against the cable clip.
• To remove slack from a cable with adjustable sets of holds in a U-bracket, remove the nut and bolt that hold the adjustable cable pulley in place and move the bolt up to hold the pulley in a higher set of holes to remove cable slack. Reinstall the nut and tighten it firmly to hold the bolt and pulley in place.