Cleaning the drain pump filter on a front-load washer with no access door video
This video from Sears PartsDirect shows how to access and clean the drain pump filter on a front-load washer that doesn’t have an access door. If your washer stops mid-cycle and you see lights flashing on the washer, lint and debris could be clogging the filter.
One of the [benefits of a front load washer](https://www.searshomeservices.com/blog/benefits-of-a-front-load-washer) is that you can access and clean out the drain pump filter on many models.
It’s important to clean this filter out once a month to keep your washer working correctly. In this video, we’ll show you how to remove the toe panel on a front-load washer without an access door so you can clean the drain pump filter.
For more troubleshooting tips, error code tables and repair guides, check out our DIY washer repair section.
Cleaning the drain pump filter
Hi, this is Wayne with Sears Parts Direct. Today we're going to talk about how to remove and clean the drain pump filter on a front-load washer that does not have an access door. Some front-load washers have a small access door near the bottom of the front panel to open and remove the filter for cleaning. Some don’t.
On this kind, you’ll need to remove the toe panel to access the drain pump filter. The drain filter traps lint and other debris. A dirty or clogged filter will cause the washer to stop in mid-cycle. You may see all the lights on your washer flashing, or if you know how to check error codes, you could look those up in your tech sheet.
Access the filter
To keep this from happening, remove and clean the drain pump filter once a month. First, make sure the washer is empty and then disconnect the power by unplugging the washer or by turning off the house circuit breaker. Next, remove the screws from the bottom of the toe panel. Pull the bottom away from the washer, slide the panel down and set it aside. Now, place a towel on the cabinet base in front of the drain pump to collect any water that may come from the filter cover when you pull it out. Grasp the handle on the front of the filter cover, rotate it counterclockwise and then pull the filter out for cleaning.
Clean the filter and seal
Check inside the filter housing for any debris. Rinse the filter clean. Remove the rubber seal and clean that, too. Replace the seal if it's damaged to prevent water leakage. Reinstall the rubber seal before putting the filter back into place. Insert the filter back into the housing. The filter has a positioning tab that has to face upward to match the corresponding slot in the filter housing. Once the filter is properly seated, hand-tighten the cover by turning it clockwise and reinstall the toe panel. Check and clean your filter monthly to avoid damage and to keep your washing machine working.
Hey, thanks for watching. I hope this video helped you out today. Be sure to check out our other videos here on the YouTube channel, and I hope you subscribe.
Symptoms for front-load washers
Main causes: bad door lock assembly, wiring failure, bad electronic control board, drain system failure, bad water-level…
Main causes: leaky water supply hoses, clogged drain system, torn door boot, cracked outer tub, overfilling…
Main causes: garments left in the washer, damaged spin basket, worn outer tub bearing, faulty drive motor, bad electroni…
Repair guides for front-load washers
How to replace a water inlet valve on a front-load washer
The water valve assembly is the gatekeeper for water entering your front-load washer. You can replace it yourself, follo…
How to replace a motor control board on a front-load washer
The motor control board makes sure the motor spins in the right direction and at the right speed. You can install a new …
How to replace the user interface board in a front-load washer
Follow these steps to replace the user interface board in your front-load washer if the buttons or lights are broken.…
Articles and videos for front-load washers
Find tips for using your washing machine efficiently to save energy and help reduce utility bills.…
Get answers to frequently asked questions about Sears and Sears PartsDirect.…
See how to access and clean the drain pump filter on a front-load washer without an access door.…