How to fix a pull cord stuck after tipping mower
So you tipped your lawn mower over for maintenance or cleaning and now the pull cord won’t budge. No worries, this video from Sears PartsDirect shows you how to easily get the starter rope working again in just a few minutes. And you can get back to cutting grass.
If you need help with other mower issues, our DIY walk-behind mower repair page has symptom advice, troubleshooting videos, repair guides and maintenance articles. Once you’ve diagnosed the problem, find the part you need on our lawn mower parts page.
If you can't pull the starter rope on your walk-behind mower after tipping it over for maintenance or cleaning, the engine could be hydrolocked. Hydrolocking happens when if you tip the mower the wrong way and oil flows into the engine cylinder, keeping the piston from moving.
Don't worry—we can help you fix the problem without a visit to the repair shop.
Follow these simple steps to get the mower going again.
How to fix a stuck lawn mower starter cord
Remove the spark plug and move the spark plug wire out of the way.
Pull the starter rope several times to clear oil out of the cylinder. You'll see oil spray out of the spark plug hole.
Wipe off the oil and reinstall the spark plug. Then connect the spark plug wire.
Pull the starter rope to start the engine.
A lot of white smoke will come out of the muffler as the engine sputters to life, because the engine is burning off the oil inside the cylinder.
Once the engine burns off the oil, the mower should run smoothly.
To avoid hydrolocking the engine in the future, follow the owner's manual instructions for tilting your mower. With most push mowers, you can tip the mower backward or on its side with the air filter facing upward.
We hope this video helps you out today. Find more DIY tips in the repair help section of our website at SearsPartsDirect.com or on the Sears PartsDirect YouTube channel.
Symptoms for gas walk-behind mowers
Choose a symptom to see related walk-behind mower repairs.
Main causes: damaged cutting blade, loose cutting blade, damaged flywheel key, engine needs tune up…
Main causes: uneven wheel height settings, damaged wheel, dull or damaged cutting blade…
Main causes: engine needs tune up, dirty or clogged carburetor, damaged flywheel key…
Main causes: drive control cable failure, worn or broken drive belt, bad transmission, broken drive wheel…
Main causes: stale gas, engine needs tune up, bad spark plug, dead battery, bad recoil starter, faulty safety switch, ba…
Main causes: dirty carburetor, bad spark plug, clogged air filter, engine choke problems, clogged gas cap vent…
Repair guides for gas walk-behind mowers
These step-by-step repair guides will help you safely fix what’s broken on your walk-behind lawn mower.
How to rebuild a lawn mower carburetor
The carburetor mixes air with fuel to drive the piston. Rebuild the carburetor if it's clogged or leaks.…
How to replace a lawn mower recoil starter on an OHV engine
Replace the recoil starter if it doesn't move when you pull the starter rope.…
How to replace a lawn mower wheel
Learn how replace a damaged wheel on a walk-behind lawn mower—it's a quick, easy fix.…
Articles and videos for gas walk-behind mowers
Use the advice and tips in these articles and videos to get the most out of your walk-behind lawn mower.
Learn about all the convenient features on our Sears PartsDirect website that make your parts purchases easier.…
Get answers to frequently asked questions about Sears and Sears PartsDirect.…
A blade obstruction, bad recoil starter or locked-up engine can prevent the pull cord on your mower from working. See ho…