How to replace a lawn mower wheel
This lawn mower repair guide gives step-by-step instructions for how to replace a lawn mower wheel. Lawn mower wheels can wear out with normal use. Fortunately, replacing a wheel is an easy repair. Before ordering the replacement lawn mower wheel, also check the axle shafts for wear and damage. Replace worn axle shafts at the same time to prevent the new wheels from wearing prematurely. Replace the wheels and axle shaft using the manufacturer-approved replacement parts.
These steps show how to replace the wheel on common Craftsman, MTD, Cub Cadet, Husqvarna, Yard-Man, Troybilt, Toro and Murray walk-behind lawn mowers.
Instructions
- 01.
Elevate the mower
Wear work gloves to protect your hands.
Lift the mower and slide a block of wood under the housing to support the mower with the wheels off the ground.
If the mower is heavy, have a helper lift the mower while you position the block of wood.
- 02.
Remove the wheel
Use a slot screwdriver to pry off the hub cap.
Remove the nut that secures the wheel to the axle shaft and slide the wheel off the shaft. If the nut has a washer, remember its location.
Tip: If your mower has a cotter pin instead of a nut, use pliers to remove the cotter pin.
PHOTO: Pry off the hub cap.
PHOTO: Remove the nut that holds the wheel to the axle shaft.
PHOTO: Slide the wheel off the axle.
- 03.
Clean the axle shaft
Use a clean rag or paper towel to wipe debris off the axle shaft, to prevent the new wheel from binding.
Tip: Don't apply oil or grease to the axle, because dirt sticks to these lubricants. - 04.
Install the new wheel
Install the new wheel on the axle and secure in place with the nut. Attach the hub cap, if there is one.
- 05.
Lower the mower
Remove the block of wood from under the mower.
Symptoms for gas walk-behind mowers
Choose a symptom to see related walk-behind mower repairs.
Main causes: damaged cutting blade, loose cutting blade, damaged flywheel key, engine needs tune up…
Main causes: uneven wheel height settings, damaged wheel, dull or damaged cutting blade…
Main causes: engine needs tune up, dirty or clogged carburetor, damaged flywheel key…
Main causes: drive control cable failure, worn or broken drive belt, bad transmission, broken drive wheel…
Main causes: stale gas, engine needs tune up, bad spark plug, dead battery, bad recoil starter, faulty safety switch, ba…
Main causes: dirty carburetor, bad spark plug, clogged air filter, engine choke problems, clogged gas cap vent…
Repair guides for gas walk-behind mowers
These step-by-step repair guides will help you safely fix what’s broken on your walk-behind lawn mower.
How to rebuild a lawn mower carburetor
The carburetor mixes air with fuel to drive the piston. Rebuild the carburetor if it's clogged or leaks.…
How to replace a lawn mower recoil starter on an OHV engine
Replace the recoil starter if it doesn't move when you pull the starter rope.…
How to replace a lawn mower wheel
Learn how replace a damaged wheel on a walk-behind lawn mower—it's a quick, easy fix.…
Effective articles & videos to help repair your walk-behind mowers
Use the advice and tips in these articles and videos to get the most out of your walk-behind lawn mower.
Learn about all the convenient features on our Sears PartsDirect website that make your parts purchases easier.…
Get answers to frequently asked questions about Sears and Sears PartsDirect.…
Learn about the different kinds of mower blades and how to maintain them.…