Kenmore Elite dryer error codes

Unplug the dryer for 5 minutes and then plug it in. If the code returns, then replace the main electronic control board.

A button is stuck on the keypad on one of the two user interface control assemblies in the console. If you can't free the button, replace the user interface control assembly with the stuck button.

The heater relay on the main electronic control board failed. Unplug the dryer and replace the main electronic control board.

The control detects an electrically open outlet thermistor (temperature sensor). Unplug the dryer and check the resistance of that thermistor, which should be about 10,000 ohms. If the outlet thermistor is defective, replace it.

The control detects an electrically shorted outlet thermistor (temperature sensor). Unplug the dryer and check the resistance of that thermistor, which should be about 10,000 ohms. If the outlet thermistor is defective, replace it.

The control detects an electrically open inlet thermistor (temperature sensor). Unplug the dryer and check the resistance of that thermistor, which should be about 50,000 ohms. If the inlet thermistor is defective, replace it. NOTE: The inlet thermistor is combined with the high-limit thermostat on this dryer.

The control detects an electrically shorted inlet thermistor (temperature sensor). Unplug the dryer and check the resistance of that thermistor, which should be about 50,000 ohms. If the inlet thermistor is defective, replace it. NOTE: The inlet thermistor is combined with the high-limit thermostat on this dryer.

Unplug the dryer and check the wiring connections on the moisture sensor. If the wiring connections are sound, replace the the moisture sensor.

Unplug the dryer and check the wiring connections on the moisture sensor. If the wiring connections are sound, replace the the moisture sensor.

Clean lint from the lint screen. If you use fabric softener sheets, wash the lint screen with water and a soft-bristled brush to remove fabric softener buildup. Clear any clog or restriction from the exhaust air duct system to the outside of your home.

The L2 leg of 240 volt power is below 30 volts. Check the house circuit breakers for the dryer and reset the L2 breaker if it's tripped. Unplug the dryer and check the power cord wire connections on the terminal block. Reconnect any loose wires or replace the power cord if it's damaged. Have an electrician check the 240 volt power supply for the dryer.

Unplug the dryer. Check the wire harness connections between the main electronic control board and the user interface control board assemblies. If the connections are sound, contact a technician to diagnose the cause of the communication failure. The main electronic control board and/or the user interface control assemblies may might need to be replaced.

Unplug the dryer. Check the wire harness connections between the user interface assemblies. Also check the wire harness connections between the main electronic control board and the user interface assemblies. If the wiring connections are okay, one or both user interface control assemblies probably needs to be replaced.