Gas Pressure Washer: Why does my pressure washer's engine lose power?

The engine on a pressure washer needs enough clean air to run properly, so replace the air filter if it's dirty. The engine also needs clean, fresh gasoline, so replace the fuel in the gas tank if the fuel is older than 3 months. If the carburetor is gummed up, the engine loses power, so check the carburetor and rebuild it if necessary. Replace the carburetor if it's too dirty to clean.

If the engine starts and run fine for several minutes but then loses power, the unloader valve may have failed. A failed unloader valve won't recirculate water back to the pump inlet, so pump outlet pressure builds up, making it harder for the engine to run the pump. The engine bogs down when it struggles to run the pump.

Try this test to see if a bad unloader is causing the engine to lose power. Stop the engine and remove the nozzle from the tip of the wand. Start the engine and hold the wand trigger down so water flows freely out of the wand. If the engine continues to run smoothly instead of bogging down after several minutes, then you'll likely need to replace the unloader valve.