CONFIRM THE PART FITS
Part Information
Helpful DIY instructions: Installation guide.
This carburetor (part number 545006017) is for line trimmers.
Carburetor 545006017 mixes air and gas before the fuel mix goes to the engine.
Wear work gloves to protect your hands and work in a well-ventilated area during this repair.
Top models using the same part
| Model Name | Model Number | Diagram Name |
|---|---|---|
| Model #PPB250E Poulan gas line trimmer | PPB250E | Cylinder/crankcase/crankshaft |
| Model #PPB300E TYPE 1 Poulan gas line trimmer | PPB300E TYPE 1 | Cylinder/muffler/crankshaft |
| Model #PPB250E TYPE 2 Poulan gas line trimmer | PPB250E TYPE 2 | Cylinder/crankshaft/crankcase |
| Model #PPB250E TYPE 1 Poulan gas line trimmer | PPB250E TYPE 1 | Cylinder/crankshaft/crankcase |
| Model #358791061 Craftsman gas line trimmer | 358791061 | Cylinder/crankshaft/crankcase |
| Model #358791060 Craftsman gas line trimmer | 358791060 | Cylinder/crankshaft/crankcase |
| Model #PPB150E TYPE 2 Poulan gas line trimmer | PPB150E TYPE 2 | Cylinder/crankshaft/crankcase |
| Model #358791801 Craftsman gas line trimmer | 358791801 | Cylinder/crankshaft/crankcase |
| Model #PPB100E Poulan gas line trimmer | PPB100E | Cylinder/crankshaft/crankcase |
| Model #PPB300E TYPE 2 Poulan gas line trimmer | PPB300E TYPE 2 | Cylinder/crankshaft/muffler |
Reviews
Craftsman carburetor
Hard to do they sent the wrong part. Package was labeled correctly but it wasn't a carburetor kit in it. Some kind of ignition pary
Craftsman t, Vernon Conn
Did you find this review helpful?
- Ease of Installation
- Very Difficult
- Duration of Installation
- More than 2 hours
Yes, I would recommend this to a friend
Happy with Delivery of Weedwacker Parts
Kit was delivered when promised. All parts ordered were in the box. The small green gasket, that I needed, came packed with other fiber gaskets that I had no use for in my Weedwacker engine. The collection of parts was priced fairly.
Eccentric 2, Undisclosed
Did you find this review helpful?
- Ease of Installation
- Easy
- Duration of Installation
- 30 minutes - 1 hour
Focus not fit
After spending at least 15 to 25 minutes online chat with agent carburetor is different configuration. The choke lever is approximately 1 to 2 inches longer than the original. The fuel line I advised her and chat but the picture that was shown was completely different from the carburetor on my unit however, she advised me that the right one would be shipped. Very disappointed will be returning hoping to receive both ways shipping and part cost from Sears as it is their fault that it did not fit properly after speaking to the agent for a lengthy amount of time.
Hgsjoiubvsd, Undisclosed
Did you find this review helpful?
- Ease of Installation
- Very Difficult
- Duration of Installation
- More than 2 hours
Carburator and connecting parts
It is rather difficult to get the gas lines on the connections. That was the most consuming time as it took probably30-40 minutes to finally get all of them connected.
Jim42, Newburgh, Indiana
Did you find this review helpful?
- Ease of Installation
- Difficult
- Duration of Installation
- 1 - 2 hours
Trimer carburator easy to install
Its very easy to install and didn't have to do any adjustment took about 20 minutes
lillo57, Collegeville Pa.
1 person thought this review was helpful.
- Ease of Installation
- Very Easy
- Duration of Installation
- Less than 30 minutes
Was very easy to install
Very easy to install. Engine cranked and ran perfectly on first pull of the rope.
Bob67, New Braunfels, Texas
1 person thought this review was helpful.
- Ease of Installation
- Very Easy
- Duration of Installation
- Less than 30 minutes
Put on crank up
Put new card on weed wacker,no adjustment needed to card.Just adjust idle speed and you are ready to do some serious weed eating.
Stroker, Clayton NC
2 people thought this review was helpful.
- Ease of Installation
- Very Easy
- Duration of Installation
- 30 minutes - 1 hour