CONFIRM THE PART FITS

Snowblower Shift Rod Cam Lock (replaces 8417) 8417MA

Part #8417MA

Online Only Price
$49.93
| 
11% OFF Phone Price : $55.93
In Stock
For ZIP codes near Edit
60-day return policy 

Part Information

This shift rod cam lock (part number 8417MA) is for snowblowers.

Shift rod cam lock 8417MA attaches in the cam bracket below the auger drive lever and locks the drive lever in place when the drive lever is engaged.

Wear work gloves to protect your hands when installing this part.

Reviews

Easy to install however....
January 27, 2021

It was easy to install however, I wish I bought at least 1 push nut. 1 definitely needs to be replaced when changing the cam lock.

Snow l, Vermont

Did you find this review helpful?

Ease of Installation
Very Easy
Duration of Installation
Less than 30 minutes

Yes, I would recommend this to a friend

A new cam lock on Craftsman snowblower 536.887752.
April 24, 2020

The installation of this part was rather easy. I removed the left push-on nut (#801 in the manual's exploded drawing) with a large screw driver by twisting the screw driver at several locations around the nut. Then I removed the spring pivot pin (#800) along with the push-on nut at the other end of the pin. The existing cam lock (#799) can then be removed. I put some grease on the spring pivot pin and inside the new cam lock, put the new cam lock in position, and then reinserted the spring pivot pin through the new cam lock. I then put a metal block (wood might work too) to the right between the spring pivot pin and the blower housing, lightly tapped with a hammer on the push-on nut that was previously removed, and then hit the push-on nut hard with a hammer put force it back on the spring pivot pin. That finished the project.

Jim W, Rochester, MN

Did you find this review helpful?

Ease of Installation
Easy
Duration of Installation
30 minutes - 1 hour

Yes, I would recommend this to a friend

Easy fix. Cam lock replacement.
March 09, 2020

Pop off lock nut, remove shaft, remove broken cam lock straiten any bent rods align them to each other, hold new part in the correct position insert shaft and put on new lock nut, I used a c clamp to press the 3/8" lock back on to the shaft.

Couzturt, Westford, NY

Did you find this review helpful?

Ease of Installation
Easy
Duration of Installation
Less than 30 minutes

Yes, I would recommend this to a friend

Miss leading sales of replacement part
December 28, 2019

could not locate on you tube how to install cam lock

Jon O, Sioux Falls, South Dakota

Did you find this review helpful?

Ease of Installation
Very Difficult
Duration of Installation
More than 2 hours

Yes, I would recommend this to a friend