Official Frigidaire gas range parts

How to replace the oven temperature sensor in your Frigidaire gas range

• Shut off electrical power and the gas supply to the range.
• Remove the oven racks.
• Remove the screws from the base of the temperature sensor probe.
• Carefully pull the oven temperature sensor probe forward into the oven interior. The wires connected to the probe have enough slack that you can pull it a just few inches. Holding the connector with needle-nose pliers, depress the locking tab on the plug and disconnect the plug from the sensor probe. Don't let the connector slip back through the hole, or you must remove the back panel of the oven to retrieve it.
• While holding the connector with a pair of needle-nose pliers, snap it into the plug of the new probe. Push the wire into back wall of the oven. Position the new sensor probe and line up the holes for the mounting screws. Insert the mounting screws and tighten firmly using a nut driver.
• Reinstall the oven racks and turn on the electricity and gas.

Top replacement parts for your Frigidaire gas range

• Oven temperature sensor probe. The oven temperature sensor probe detects the actual temperature in the oven cavity. Replace it if it's not detecting the temperature properly, in which case the oven doesn't maintain the temperature you set. A complete failure, in which the sensor probe doesn't detect any temperature at all, usually triggers an error code on the electronic oven control board.
• Electronic oven control board. The electronic oven control (EOC) board governs the timing and execution of oven functions such as baking and broiling. It's usually in the control console and often has a digital clock on the front of its housing. Replace the electronic control board if it doesn't light up when it's supplied with electrical power, if it doesn't operate properly or doesn't properly send current to the oven igniter.
• Surface burner spark igniter switch. The igniter switch is an electrical switch on the stem of the gas surface burner control valve. This switch completes a circuit to the surface burner spark module, causing the burner igniters to spark when the burner switch is turned to the Lite position. Replace the burner igniter switch if the burners don't spark when you turn the burner control knob to the Lite position or if igniters spark constantly even when the burner knobs are in the Off position.