Can’t find your part?   Contact us:
+1-309-603-4777
Sears Parts Direct
Orders

  • Keep track of the models you own in your profile

    Sign in or Register to view or add models

Schedule a repair
Yard-Man Chipper shredders

Official Yard-Man chipper/shredder parts

Yard Man chipper/shredders make quick work of brush and branch disposal. Sharp blades in your Yard Man chipper/shredder cut through any type of debris that you load in the chute. When your Yard Man chipper/shredder isn't working as it should, get the replacement parts you need to fix the machine at Sears PartsDirect.

How to start the engine on your Yard Man chipper/shredder

  • Check the engine oil for proper level. Add oil if needed. Make sure the fuel tank is full of gas.
  • Set the throttle to FULL and close the choke. NOTE: A warm engine may not require choking.
  • Place one foot on the front support leg to hold the unit firmly in place.
  • Pull the starter rope out to begin turning the engine over. Pull slowly at first and increase speed with each successive pull.
  • After the engine starts, open the choke and move the engine throttle control to SLOW. Warm up the engine by running it for at least a minute.
  • Set the throttle to FULL and begin chipping/shredding.

Installing the hopper on your Yard Man chipper/shredder

  • Attach the hopper to the rotor housing. Make sure that you engage the metal lip of the hopper liner inside the rotor housing.
  • Secure the hopper to the rotor housing using the mounting bolts and washers. Don't tighten the mounting bolts at this time.
  • From inside the hopper, install the mounting bolts and washers into the upper lower holes of the metal hopper liner. Finger tighten the bolts at this time.
  • Make sure that the hopper is seated correctly on the chipper/shredder then tighten all mounting bolts firmly.

Parts & More