Can’t find your part?   Contact us:
+1-309-603-4777
Sears Parts Direct
Orders

  • Keep track of the models you own in your profile

    Sign in or Register to view or add models

Schedule a repair
Porter Cable Chipper shredders

Official Porter Cable chipper/shredder parts

Porter Cable chipper/shredders are known for their reliability and top performance. Although Porter Cable chipper/shredders rarely break down, you can never tell when parts will eventually wear out. Find the replacement parts you need to keep your Porter Cable chipper/shredder running at Sears PartsDirect.

How to start the engine on your Porter Cable chipper/shredder

  • Check the engine oil for proper level. Add oil if needed. Make sure the fuel tank is full of gas.
  • Set the throttle to FULL and close the choke. NOTE: A warm engine may not require choking.
  • Place one foot on the front support leg to hold the unit firmly in place.
  • Pull the starter rope out to begin turning the engine over. Pull slowly at first and increase speed with each successive pull.
  • After the engine starts, open the choke and move the engine throttle control to SLOW. Warm up the engine by running it for at least a minute.
  • Set the throttle to FULL and begin chipping/shredding.

Common replacement parts for Porter Cable chipper/shredders

  • Engine air filter. The engine air filter cleans the air entering the carburetor. Replace the air filter periodically, following the guidelines in the owner's manual.
  • Carburetor. The engine carburetor mixes air and gas before the fuel mix goes to the cylinder for combustion.
  • Recoil starter. The recoil starter spins the crankshaft to start the engine when you pull the rope.
  • Engine gasket set. The engine gasket set includes all of the seals and gaskets for the engine on your chipper/shredder. Replace any gaskets that are damaged or leaking.

Parts & More