How to replace a dishwasher electronic control board
This repair guide gives step-by-step instructions for replacing a dishwasher electronic control board. The electronic control board runs all the dishwasher's functions—filling, washing, drying and draining—which can make it difficult to pinpoint the control board as the source of a problem. Refer to the tech sheet for diagnostic tests (it's usually behind the service panel below the door) or have a local dishwasher repair expert test the dishwasher electronic control board. If the electronic control board is faulty, replace it with a manufacturer-approved replacement part.
These basic instructions will help you replace the electronic control board in many Kenmore, Whirlpool, KitchenAid, Maytag, JennAir, Amana, GE, Frigidaire, Electrolux, LG and Samsung dishwashers.
How to replace a dishwasher electronic control board.
Instructions
- 01.
Shut off electrical power
Unplug the dishwasher or shut off the house circuit breaker for the dishwasher.
To verify that power is disconnected, make sure that the control panel doesn’t light up when your press a control button or the power button.
PHOTO: Shut off the house circuit breaker.
- 02.
Remove the outer door panel and control panel
With the dishwasher door open, remove the Torx screws from the inner door panel. Support the outer door panel with one hand as you remove the final 2 screws so the outer door panel doesn't fall.
Separate the outer door panel and control panel slightly from the inner door panel, and let the outer panel rest on the floor while you disconnect the user interface control wire harness from the control panel.
Pull off the outer door panel and control panel.
PHOTO: Remove the outer dishwasher door panel.
- 03.
Remove the electronic control board
Lift the locking tab, slide the control board slightly left and then release it from the inner door panel.
Release the cover locking tabs and remove the electronic control board cover.
Release the wire harness connector brace and connector box cover.
Disconnect the electronic control board wires.
PHOTO: Release the locking tab on the control board.
- 04.
Install the new electronic control board
Remove the cover from the new electronic control board.
Connect the electronic control board wires to the new control board.
Install the wire harness connector brace and connector box cover.
Reinstall the electronic control board cover.
Push the new electronic control board into the mounting slots and slide it to the right to engage the locking tab.
PHOTO: Connect the wires to the new electronic control board.
- 05.
Reinstall the outer door panel and control panel
Position the outer door panel and control panel close enough to the inner door so you can reconnect the user interface control wire harness.
Reconnect the user interface control wire harness and attach the outer door panel and control panel to the inner door panel.
Reinstall the mounting screws.
Tip: Use the longer screws to secure the control panel.
PHOTO: Reinstall the outer door panel.
- 06.
Restore electrical power
Reset the house circuit breaker or plug in the dishwasher to restore electrical power.
Most common symptoms to help you fix your dishwashers
Choose a symptom to see related dishwasher repairs.
Main causes: glass or popcorn kernel stuck in the chopper blade, drain line vibrating against the cabinet, debris in was…
Main causes: not using rinse aid, rinse aid dispenser failure, broken heating element, malfunctioning vent, drying fan f…
Main causes: damaged or stuck spray arm, leaking door seal, damaged door hinge, leaky heating element water seal, cracke…
Main causes: clogged kitchen sink drain, clogged drain hose, drain check valve damaged, drain pump failure, control syst…
Main causes: broken door spring, damaged or broken door hinge…
Main causes: broken door latch, tripped circuit breaker, broken heating element, faulty vent fan, sensor failure, contro…
Main cause: damaged rack height adjuster…
Main causes: improper loading, low water temperature, improper detergent dosage, detergent dispenser failure, spray arm …
Main causes: light switch beside the sink turned off, lack of power, bad dishwasher door switch, control system failure,…
Most common repair guides to help fix your dishwashers
These step-by-step repair guides will help you safely fix what’s broken on your dishwasher.
How to replace a dishwasher high-limit thermostat
Follow these steps to replace the high-limit thermostat in your dishwasher if prevents the heating element from heating.…
How to replace a dishwasher door outer panel
If your dishwasher door is dented or you want it to match your cabinets or other appliances, this guide shows how to rep…
How to replace a dishwasher thermal fuse
A completely dead control panel often indicates that the thermal fuse on the electronic control board is blown; follow t…
Effective articles & videos to help repair your dishwashers
Use the advice and tips in these articles and videos to get the most out of your dishwasher.
Get tips on completing essential holiday cleaning tasks to brighten your home.…
Learn about all the convenient features on our Sears PartsDirect website that make your parts purchases easier.…
Get answers to frequently asked questions about Sears and Sears PartsDirect.…