How to replace a trash compactor momentary start switch
This DIY repair guide explains how to replace the momentary start switch on a trash compactor. The momentary switch, located behind the front frame cover on the right, starts the motor to compact trash when you lift the foot pedal. If the motor won't start when you activate the momentary start switch, replace the switch with the manufacturer-approved trash compactor part.
Follow these steps to replace the momentary start switch on Kenmore, KitchenAid, Whirlpool, Maytag and JennAir trash compactors.
Instructions
- 01.
Pull the trash compactor out of the counter
Lay cardboard in front of the trash compactor to protect the floor, then remove the mounting screws that secure the trash compactor in the counter. Pull the trash compactor out of the counter.
Tip: Use your installation manual as a guide. - 02.
Disconnect electrical power
Unplug the trash compactor or shut off the house circuit breaker.
- 03.
Remove the drawer
Pull the drawer out until it stops.
Grasp the drawer handle firmly and lift the front of the drawer until the rail stops clear the drawer rail.
Carefully lift the drawer out of the compactor and set it aside.
PHOTO: Pull the drawer out until it hits the rail stops.
PHOTO: Lift the drawer up to clear the rail stops and remove the drawer.
- 04.
Remove the top cover
Remove the mounting screws that secure the top cover to the trash compactor frame. Pull the top cover off and set it aside.
PHOTO: Remove the top panel screws.
PHOTO: Remove the top panel.
- 05.
Release the front frame
Remove the air filter.
Remove the mounting screws that secure the front frame to the trash compactor.
Pull the frame off the front of the trash compactor. The switch wires are still attached.
PHOTO: Remove the air filter cover.
PHOTO: Remove the air filter.
PHOTO: Remove the top frame screws.
PHOTO: Remove the side frame screws.
PHOTO: Pull off the front frame.
- 06.
Remove the momentary start switch
Note the location of wires or take a digital photo of the connections before removing the wires..
Pull the wires off the start switch.
Release the clips that hold the switch in the front frame and pull the switch out.
PHOTO: Pull off the switch wires.
PHOTO: Remove the start switch.
- 07.
Install the new momentary start switch
Push the new momentary start switch into the front frame until the locking tabs snap into place.
Connect the wires to the new momentary start switch, using the digital photo or notes for reference.
- 08.
Reinstall the front frame
Position the front frame on the front of the trash compactor and install the mounting screws.
Reinstall the air filter.
PHOTO: Reinstall the front frame.
PHOTO: Reinstall the front frame screws.
PHOTO: Reinstall the air filter.
- 09.
Reinstall the top cover
Position the top cover and install the mounting screws.
PHOTO: Reinstall the top cover.
- 10.
Reinstall the drawer
Tilt the drawer up and insert the drawer rails into the rails on the inside frame of the compactor.
Slide the drawer in and make sure that it shuts and opens properly.
PHOTO: Reinstall the drawer.
- 11.
Restore power
Plug in the trash compactor or reset the house circuit breaker.
- 12.
Reinstall the trash compactor in the counter
Slide the trash compactor into the counter opening and install the mounting screws.
Most common symptoms to help you fix your trash compactors
Choose a symptom to see related trash compactor repairs.
Main causes: broken drive gear and sprocket chain, stripped power nuts, faulty top limit and directional switch...
Main causes: stuck foot pedal, bad momentary start switch, power switch failure...
Main cause: broken top limit and directional switch...
Main causes: bent drawer support rollers, damaged trash container...
Main causes: stripped or broken power nuts, broken or disconnected drive gear and sprocket chain, damaged drive parts...
Main cause: faulty drawer tilt switch ...
Main causes: lack of power, faulty drawer safety switch, bad power switch, momentary start switch failure, bad drive mot...
Most common repair guides to help fix your trash compactors
These step-by-step repair guides will help you safely fix what’s broken on your trash compactor.
How to replace a trash compactor power switch
If the trash compactor won’t power up, use the steps in this repair guide to replace the power switch....
How to replace a trash compactor momentary start switch
The momentary start switch starts the motor when you lift the foot pedal. This repair guide shows how to replace the swi...
How to replace a trash compactor motor centrifugal switch
If the trash compactor ram won’t return to the top position, replace the motor centrifugal switch by following the instr...
Effective articles & videos to help repair your trash compactors
Use the advice and tips in these articles and videos to get the most out of your trash compactor.
Learn about all the convenient features on our Sears PartsDirect website that make your parts purchases easier....
Get answers to frequently asked questions about Sears and Sears PartsDirect....
Learn what to check if you are having problems with the drawer sticking on your trash compactor....