15 minute or less install . Removed back of cabinet . Unplugged thermostat . Took out 2 mounting screws and replaced .
Ease of InstallationVery Easy
Duration of InstallationLess than 30 minutes
verified customer
Yes, I would recommend this to a friend
Was this review helpful?
10 minute install
May 10, 2019|Jim t h, California
All parts well marked and fit first try. Documentation was clear.
Ease of InstallationEasy
Duration of InstallationLess than 30 minutes
verified customer
Was this review helpful?
easy to install
April 10, 2018|Yeeimy, Bronx
my order arrived on time and it was easy to install.
Ease of InstallationVery Easy
Duration of InstallationLess than 30 minutes
verified customer
1 person thought this review was helpful.
Easy to install.
April 02, 2018|joec, Miami, FL
The Sears video and part drawing was very helpful in determining if I was getting the right part.
Ease of InstallationVery Easy
Duration of InstallationLess than 30 minutes
verified customer
1 person thought this review was helpful.
No instructions...for setting temperature.
July 24, 2018|BrainDeadJones, Chicago
While I didn't need instructions to install the device, the Thermostat itself is variable, and needs to be set in order to avoid major issues ranging from poor performance or early failure to a fire... After scouring the internet I found the unit has a range of 135 to 155 degrees Fahrenheit. Setting A = 135, B = 140, C = 145, D = 150, and E = 155 degrees. I will gladly pay the extra 50 cents for a guide thank you. What should have been a half hour fix, turned into a 2 hour event. Hope this helps the next buyer.
Ease of InstallationVery Easy
Duration of Installation1 - 2 hours
verified customer
3 people thought this review was helpful.
Quick Install
February 13, 2018|boywva, Plato, Missouri
It only took me about 30 minutes to have the part installed and the dryer working.
Ease of InstallationEasy
Duration of Installation30 minutes - 1 hour
verified customer
1 person thought this review was helpful.
Variable temp is very touchy
December 23, 2019|J. S, Sheffield AL
It is a variable temp control which means if you needed a 170 degree switch ya gotta play with it to get it close. Which means Dryer out, back off, move dial, reassemble test. Be a whole lot easier if the settings were in degrees on the dial, but they are not. Took me 6 times to get it near 120 and I wanted it higher but got fed up with the process.
Ease of InstallationVery Easy
Duration of InstallationLess than 30 minutes
verified customer
Yes, I would recommend this to a friend
Was this review helpful?
If you're not handy don't attempt this
July 07, 2018|WC s, H. H. ,KY
The dryer must be pulled out from the wall along with disconnecting the vent and the gas line. The back of the dryer must be removed, at that point it's only two screws into wires to replace the part. Use the vacuum to clean everything out inside and outside the dryer and the floor And then put it all back together double check your connections turn on and test.
verified customer