Refrigerator Light Board (replaces W10412708, W11205083) W10695459

LED light replacement

Really easy fix just make sure you have a really thin putty knife to push in the clips to pop out the old LED light might have to cut some refrigerator foam out to get to the connector have a pair of needle nose pliers handy that's all I needed to change it took about 15 minutes

Ease of Installation

Easy

Duration of Installation

Less than 30 minutes

Yes, I would recommend this to a friend

Perfect replacement

Part was easy to replace. Just wish original part lasted longer than 2 years.

Ease of Installation

Easy

Duration of Installation

Less than 30 minutes

Yes, I would recommend this to a friend

Connectors were too big to fit in refrigerator

The light I was replacing was hard-wired so I had to cut the small plug off and use the provided wire connectors. It was very hard to reach since wires are short and located back in the top of the freezer compartment. Once I finally had the connectors attached, they were too big to fit back in the recess where the light snaps in, so I had to use electrical tape to hold it in place. Light works, but it isn't properly set all the way in place.

Ease of Installation

Very Difficult

Duration of Installation

More than 2 hours

Wrong connector.

The picture on the internet shows that it comes with a black connector, however when the part arrived it had a white connector which would not fit into the female connector on my refrigerator. According to Whirlpool this is the new replacement part so I needed to find somebody that will solder the old connector onto the new part.

Ease of Installation

Difficult

Duration of Installation

1 - 2 hours

Yes, I would recommend this to a friend