Official Hoover side-by-side refrigerator parts

Replacing the water inlet valve in your Hoover side-by-side refrigerator

• Safely store any food that could deteriorate while the refrigerator is shut off. Then unplug the refrigerator or shut off the circuit breaker for the refrigerator. Close the water supply cut-off valve for the ice maker. The valve is often on the wall behind the refrigerator, but could be attached to a water pipe under the kitchen sink or in the basement below the fridge.
• Pull the refrigerator away from the wall far enough so you can access the water line connection and work on the back of the refrigerator. Place a towel under the water valve assembly to catch water. Loosen the nut on the supply water line until the water line is free.
• Use a Phillips screwdriver to remove the screws that secure the lower service panel on the back of the refrigerator. Remove the panel. Remove the screw that secures the mounting bracket to the frame of the refrigerator. Press the back of the locking tab on the wire harness to release the tab. Pull the wire harness plug off the valve. Remove the black plastic C-clip from the collar of the water line connection. Push the collar in and simultaneously pull the water line from the inlet water valve assembly.
• Push the water line into the fitting on the new water valve assembly. Reinstall the C-clip on the collar of the fitting. Push the wire harness plug back onto the spades of the water valve assembly. Push the plug in until the locking tabs snap into place. Position the bracket of the new valve assembly so that the mounting holes line up. Reinstall the mounting screw and tighten firmly. Position the lower service panel on the back of the refrigerator so that the screw holes line up. Insert the screws and tighten firmly.
• Wrap a small amount of pipe thread tape around the water supply line fitting on the back of the water valve. Fit the water line into the water valve assembly and tighten the compression nut firmly. Open the water supply cut-off valve. If the fitting leaks, tighten the compression nut and check again. Plug in the refrigerator or turn on the house circuit breaker to restore power.

Replacing a compressor start relay in a Hoover refrigerator

• Unplug the power cord from the wall outlet.
• Pull the refrigerator away from the wall. Remove the screws from the rear compartment cover and then remove the cover.
• Pry off the wire retainer holding the start relay on the compressor. Disconnect the wire harness from the start relay. Pull the start relay and run capacitor off the compressor.
• Transfer the run capacitor from the old start relay to the new start relay. Plug the new start relay with capacitor into the compressor terminals. Plug the wire harness into the new start relay. Reinstall the wire retainer to hold the start relay on the compressor.
• Position the rear compartment cover on the back of the refrigerator and reinstall the mounting screws.
• Plug in the refrigerator and push the refrigerator back into place.