Official Modern Maid side-by-side refrigerator parts

What to do when you see ice or water at the bottom of the freezer compartment in your Modern Maid side-by-side refrigerator

When the freezer in a side-by-side refrigerator defrosts, water drains down through a defrost tube into a drain pan and eventually evaporates. If the defrost drain tube is clogged with ice or gunk, the water can't drain down the tube. Instead, it collects in a puddle at the bottom of the freezer compartment and eventually freezes to ice. Clearing the drain tube usually fixes the problem. Replace the drain tube if it's damaged or you can't clear a clog.

Water leaking from the water ice maker system can also wind up at the bottom of the freezer compartment, so check water system tubing for leaks and replace any damaged tubes.

Replacing the water inlet valve in your Modern Maid side-by-side refrigerator

• Safely store any food that could deteriorate while the refrigerator is shut off. Then unplug the refrigerator or shut off the circuit breaker for the refrigerator. Close the water supply cut-off valve for the ice maker. The valve is often on the wall behind the refrigerator, but could be attached to a water pipe under the kitchen sink or in the basement below the fridge.
• Pull the refrigerator away from the wall far enough so you can access the water line connection and work on the back of the refrigerator. Place a towel under the water valve assembly to catch water. Loosen the nut on the supply water line until the water line is free.
• Use a Phillips screwdriver to remove the screws that secure the lower service panel on the back of the refrigerator. Remove the panel. Remove the screw that secures the mounting bracket to the frame of the refrigerator. Press the back of the locking tab on the wire harness to release the tab. Pull the wire harness plug off the valve. Remove the black plastic C-clip from the collar of the water line connection. Push the collar in and simultaneously pull the water line from the inlet water valve assembly.
• Push the water line into the fitting on the new water valve assembly. Reinstall the C-clip on the collar of the fitting. Push the wire harness plug back onto the spades of the water valve assembly. Push the plug in until the locking tabs snap into place. Position the bracket of the new valve assembly so that the mounting holes line up. Reinstall the mounting screw and tighten firmly. Position the lower service panel on the back of the refrigerator so that the screw holes line up. Insert the screws and tighten firmly.
• Wrap a small amount of pipe thread tape around the water supply line fitting on the back of the water valve. Fit the water line into the water valve assembly and tighten the compression nut firmly. Open the water supply cut-off valve. If the fitting leaks, tighten the compression nut and check again. Plug in the refrigerator or turn on the house circuit breaker to restore power.