Official White-Westinghouse electric range parts

How to replace a range oven door lock assembly in your White-Westinghouse electric range

• Carefully pull the range forward and unplug it. If necessary, have someone assist you when moving the range.
• Remove the screws that secure the back panel to the range. As you remove the last couple of screws, press the panel against the range so it doesn't fall. Carefully lower the panel to the floor and then set it aside.
• Disconnect all the wires from the oven door lock motor assembly. Remove the mounting screws that hold the door lock assembly in place. To release the door lock assembly from the connecting rod, pull the oven door lock motor assembly down and tilt it in. Remove the door lock assembly from the range and discard it.
• Tilt the new oven door lock motor assembly and insert the connecting rod in the opening. Work the assembly into position and screw the door lock assembly in place. Carefully connect all the wires in the right location on the new oven door lock assembly.
• Position the outer back panel on the back of the range so that the holes line up and screw it into place.
• Plug in the range and push the range into position. Ensure that the rear leveling foot is properly engaged in the anti-tip bracket.

How to replace the oven temperature sensor in your White-Westinghouse electric range

• Shut off electrical power to the range.
• Remove the oven racks.
• Remove the screws from the base of the temperature sensor probe.
• Carefully pull the oven temperature sensor probe forward into the oven interior. The wires connected to the probe have enough slack that you can pull it a just few inches. Holding the connector with needle-nose pliers, depress the locking tab on the plug and disconnect the plug from the sensor probe. Don't let the connector slip back through the hole, or you must remove the back panel of the oven to retrieve it.
• While holding the connector with a pair of needle-nose pliers, snap it into the plug of the new probe. Push the wire into back wall of the oven. Position the new sensor probe and line up the holes for the mounting screws. Insert the mounting screws and tighten firmly using a nut driver.
• Reinstall the oven racks and restore electrical power to the range.