Whirlpool 2015 Cabrio dryer error codes

The code appears when you install the wrong electronic control board. Order and install the correct electronic control board for your model of dryer.

A stuck button on the user interface control causes this code. If you can't free the stuck key, replace the user interface control.

The user interface has an internal failure. Replace the user interface control.

Unplug the dryer and check the exhaust thermistor wiring. Reconnect any loose wires. Replace the wire harness if damaged. Check the resistance of the exhaust thermistor. It should measure about 10,000 ohms at room temperature. If the thermistor is defective, replace it. Replace the electronic control board if the exhaust thermistor and wiring are okay.

Check for a metal object shorted across the 2 metal moisture sensor bars inside the dryer. Unplug the dryer and check the moisture sensor wire harness. Reconnect any loose wires. Replace the moisture sensor wire harness if damaged.

Unplug the dryer and check the inlet thermistor wiring. Reconnect any loose wires. Replace the wire harness if damaged. Check the resistance of the inlet thermistor. It should measure about 50,000 ohms at room temperature. If the thermistor is defective, replace it. Replace the electronic control board if the inlet thermistor and wiring are okay.

Unplug the dryer and check the wire harness connections on the electronic control board heater relays and the heating element. Reconnect any loose wires. Replace the wire harness if damaged. Replace the electronic control board if the wiring is okay.

Clean the lint screen. Check the flexible vent hose behind the dryer for kinks or clogs. Clean the duct system that vents dryer air to the outside of your home. Make sure that the damper vent on the outside of your home opens properly.

The L2 leg of 240-volt power is missing. Check the house circuit breaker that supplies the L2 leg of 240-volt power to the dryer. Reset the breaker if necessary. Unplug the dryer and check the power cord wiring on the dryer terminal block. Reconnect any loose power cord connections and wire the power cord according to the directions in the installation manual. Replace the power cord if damaged. With the dryer still unplugged, check the wiring connections on the electronic control board and reconnect any loose wires. Replace the control board if you find damage.

Communication between the electronic control board and user interface control has been lost. Unplug the dryer and check the wire harness between the electronic control board and the user interface control. Reconnect any loose wires. Replace the wire harness if damaged. Replace the user interface control. If the problem persists, replace the electronic control board.