Official Hotpoint gas range parts

How to replace a Hotpoint gas range spark igniter electrode

• Shut off gas and electrical power to the range.
• Remove the grates, burner caps and burner heads.
• Remove screws that secure the top of the cooktop to the top of the burner orifice holders.
• Release the mounting clips under the front edges of the cooktop then lift the cooktop off the range and set the cooktop aside.
• Carefully disconnect the wire that's attached to the bottom of the spark igniter electrode.
• Release the metal clip from the bottom of the gas burner orifice holder and remove the clip.
• Remove the spark igniter electrode from the burner orifice holder assembly and discard it.
• Install the new spark igniter electrode and reassemble the range.
• Restore the gas supply and electrical power to the range.

How to replace the oven temperature sensor in your Hotpoint gas range

• Shut off electrical power and the gas supply to the range.
• Remove the oven racks.
• Remove the screws from the base of the temperature sensor probe.
• Carefully pull the oven temperature sensor probe forward into the oven interior. The wires connected to the probe have enough slack that you can pull it a just few inches. Holding the connector with needle-nose pliers, depress the locking tab on the plug and disconnect the plug from the sensor probe. Don't let the connector slip back through the hole, or you must remove the back panel of the oven to retrieve it.
• While holding the connector with a pair of needle-nose pliers, snap it into the plug of the new probe. Push the wire into back wall of the oven. Position the new sensor probe and line up the holes for the mounting screws. Insert the mounting screws and tighten firmly using a nut driver.
• Reinstall the oven racks and turn on the electricity and gas.